Viva 7LIECH-SC-SSF Use and Care Manual download pdf (Page 8)

INSTALLATION

To prevent accidental tip hazard, dispenser must be securely anchored to

wall as shown.

1. Place dispenser upright.

2. Locate dispenser on a hard and level surface in

a cool shaded location near a grounded wall

outlet.

Notice: Do NOT plug in power cord yet.

3. Position dispenser so the back is at least 4

inches from wall and there are at least 4 inches

of clearance on both sides.

4. Install Wall Mount Strap to prevent accidental tip

over:

• Unclip strap from back of dispenser.

• Mount strap 25 inches up from floor directly

to wall stud with screw (See illustration A)

If stud is not available, insert and turn

anchor directly into sheet rock using a

Philips screwdriver (DO NOT drill hole into

sheet rock first when using this anchor).

Secure strap by installing screw through

washer, then eyelet in strap and into wall

mounted anchor. (See illustration B)

• Position cooler in place.

• Clip strap onto back of cooler to right or

left side. (See illustration C).

• Adjust length of strap so the dispenser can

NOT move forward.

Note – Dispenser can be positioned in a corner

but still requires Wall Mount Strap to be

installed. Lengthen strap so that once installed

the dispenser cannot move forward.

IMPORTANT: Do NOT Return Dispenser To Store.

If you have a question or problem, please contact 855-VIVA-111 for assistance.

1 2 3 4 5 6 7 8 9 10 11 12 13 14

No comments

Viva 7LIECH-SC-SSF Use and Care Manual Page 8